close- Productschevron_right
- Learningchevron_right
- Manufacturing solutionschevron_right
- Supportchevron_right
CoroMill® Plura ball nose for ISO S profiling
Profiling excellence in ISO S
Performance test: Ti64Al4V / S4.2.Z.AN
| Number of flutes: | 6 |
| Operation: | Side milling |
| Coolant: | Emulsion |
+67%
Tool life
Tool life
|
| Competitor | Sandvik Coromant |
|---|---|---|
| Tool | CoroMill® Plura ball nose | |
| Grade | T2CH | |
| vc m/min (ft/min) | 375 (1230) | 375 (1230) |
| fn mm/rev (in/rev) | 0.045 (0.002) | 0.045 (0.002) |
| ae mm (inch) | 0.3 (0.012) | 0.3 (0.012) |
| ap mm (inch) | 0.1 (0.004) | 0.1 (0.004) |
| Tilt angle (°) | 12 | 12 |
| Tool life, min | 120 | 200 |
Result: After 200 minutes in cut at cutting speed 375 m/min (1230 ft/min), CoroMill® Plura ball nose end mill exhibited a remarkable 67% increase in tool life compared to the competitor.
Competitor
120 min (tool life)
Sandvik Coromant
2B286-1000-TA T2CH
120 min
Performance test: Aged Inconel 718 / S2.0.Z.AG
| Number of flutes: | 6 |
| Operation: | Side milling |
| Coolant: | Emulsion |
+100%
Tool life
Tool life
|
| Competitor | Sandvik Coromant |
|---|---|---|
| Tool | CoroMill® Plura ball nose | |
| Grade | R2AH | |
| vc m/min (ft/min) | 100 (328) | 100 (328) |
| fn mm/rev (in/rev) | 0.025 (0.001) | 0.025 (0.001) |
| ae mm (inch) | 0.3 (0.012) | 0.3 (0.012) |
| ap mm (inch) | 0.1 (0.004) | 0.1 (0.004) |
| Tilt angle (°) | 12 | 12 |
| Tool life, min | 40 | 80 |
Result: After 80 minutes in cut at cutting speed 100 m/min (328 ft/min), CoroMill® Plura ball nose end mill demonstrated an impressive 100% increase in tool life when compared to the competitor.
Competitor
40 min (tool life)
Sandvik Coromant
2B286-1000-RA R2AH
40 min
Sandvik Coromant
2B286-1000-RA R2AH
80 min
