CoroMill 300

Round insert cutter for a broad range of operations such as face milling, pocketing, and profiling. Its light cutting action allows for smooth entries and exits and for use of extended tool set-ups.

The cutters generate low cutting forces and little heat when machining with small depths of cut. This allows the table feed to be increased five to ten times compared to general machining.

Use a positive-design cutter with light cutting action for best performance and tool life. Best used in stainless steel and heat resistant super alloys.

APPLICATION

• Toroid cutters, neutral design: 10–42 mm (0.375–1.250 inch)

• Face mills and end mills, positive design: 25–200 mm (0.375–8.000 inch)